Start by Opening the front of the crate on the side with the handle bar. Then remove one side of the crate and swing the handle bar out (making sure the middle harness does not wrap around the handle bar.
Remove the zip tie from the handle bar that has the keys on it. Place the key in the power switch then turn the key to the on position and drive it off the crate. Once done turn the unit off and remove the key.
Find the box inside the crate that has the arm stop. Open it and bring it next to the machine.
Put the handle in the down position and install the handle bar stop using a 15/16” socket and ratchet.
The arm stop is used so that the unit does not turn too sharp and damage the load or the machine.
With the handle bar in the correct position find the bubble wrapped gas shocks.
Remove the top and bottom pins form the gas shocks and put the silver side of the gas shock on the knuckle it will pop on. Slide the pin through the hole and it will snap in to place
